GRBL HotWire 6.25 (XYZA)

This update addresses the problem with the CH340 driver update installed by Windows Update. This is also included in the full software and firmware download

You will need .Net Framework 4.8 installed to use the application. If this isn't installed the setup will install it for you.

It should install alongside the previous versions. If not uninstall your old version. You won't lose any settings on the controller as these are stored in the EEPROM

I've tested this on Windows 10 and 11 as much as I can but please run some dry runs before you run a live cutting job.

If there are any issues contact me via the contact page,